Ford Sierra

1982-1993 of release

Repair and car operation



Ford Siyerra
+ 1.2. Car identification
+ 2. Maintenance
- 3. General data
   + 3.1. Cars with petrol engines
   - 3.2. Cars with diesel engines
      - 3.2.1. Changes in a car design from 1988 to 1993.
         3.2.1.1. Dm3 engine 2,3
         + 3.2.1.2. Dm3 engine 1,8
         - 3.2.1.3. Fuel system
            3.2.1.3.1. Fuel filter
            3.2.1.3.2. Removal and installation of nozzles
            3.2.1.3.3. Fuel pump
         + 3.2.1.4. The repair which is not demanding removal of the engine
         3.2.1.5. Removal and engine installation
         3.2.1.6. Engine dismantling
         3.2.1.7. Check of details
         3.2.1.8. Check of gaps of a cranked shaft and rods
         3.2.1.9. Engine assembly
         3.2.1.10. Greasing system
         3.2.1.11. Cooling system
         3.2.1.12. Coupling
         3.2.1.13. Mechanical five-speed transmission of MT 75 type
         3.2.1.14. Power shaft and back bridge
         3.2.1.15. Steering system
         3.2.1.16. Forward suspension bracket
         3.2.1.17. Brake system
         3.2.1.18. Electric equipment
         3.2.1.19. General data
+ 4. Engines
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment





3.2.1.3.2. Removal and installation of nozzles

GENERAL INFORMATION

Prevention

It is necessary to protect the generator from hit in it diesel fuel.


Removal

PERFORMANCE ORDER
1. To disconnect from the accumulator a weight wire.
2. Carefully to disconnect from the fuel pump of connection of pipelines of injection.
3. Carefully to disconnect from nozzles of connection of pipelines of injection.
4. To disconnect from nozzles pipelines of return of fuel.
5. To unscrew nozzles and to establish on sprays protective caps.
6. To take washers of thermal isolation and to wipe them.

Installation

PERFORMANCE ORDER
1. To establish new washers of thermal isolation by the convex party to a head of the block of cylinders.
2. To insert nozzles into openings in a head of the block of cylinders and to tighten them the necessary moment.
3. To screw on nozzles of connection of pipelines of injection. To be convinced that brackets of fastening of pipelines (counteracting fluctuations) are on demanded places.
4. To screw connections of pipelines of injection on the fuel pump.
5. To establish on nozzles pipelines of return of fuel.
6. To connect the accumulator, to start the engine and to check tightness of connections.