Ford Sierra

1982-1993 of release

Repair and car operation



Ford Siyerra
+ 1.2. Car identification
+ 2. Maintenance
- 3. General data
   + 3.1. Cars with petrol engines
   - 3.2. Cars with diesel engines
      - 3.2.1. Changes in a car design from 1988 to 1993.
         3.2.1.1. Dm3 engine 2,3
         + 3.2.1.2. Dm3 engine 1,8
         + 3.2.1.3. Fuel system
         + 3.2.1.4. The repair which is not demanding removal of the engine
         3.2.1.5. Removal and engine installation
         3.2.1.6. Engine dismantling
         3.2.1.7. Check of details
         3.2.1.8. Check of gaps of a cranked shaft and rods
         3.2.1.9. Engine assembly
         3.2.1.10. Greasing system
         3.2.1.11. Cooling system
         3.2.1.12. Coupling
         3.2.1.13. Mechanical five-speed transmission of MT 75 type
         3.2.1.14. Power shaft and back bridge
         3.2.1.15. Steering system
         3.2.1.16. Forward suspension bracket
         3.2.1.17. Brake system
         3.2.1.18. Electric equipment
         3.2.1.19. General data
+ 4. Engines
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


http://www.audio-transcoder.com/ru/audio-converter



3.2.1.6. Engine dismantling

PERFORMANCE ORDER
1. To remove a turbokompressor together with a final collector.
2. To merge from the engine oil.
3. To remove a leading part and a coupling disk.
4. To remove a flywheel from a cranked shaft.
5. To remove maple a belt of a drive of the pump of cooling liquid.
6. To remove maple a belt of a drive of the generator.
7. To remove a head of the block of cylinders (see subsection 3.2.1.4.2).
8. To block a cranked shaft and to unscrew a bolt of fastening of a pulley of a cranked shaft.
9. To remove a pulley from a cranked shaft.
10. To remove the fuel pump (see subsection 3.2.1.3.3).
11. To remove the generator.
12. To remove the air filter.
13. To remove the oil pump.
14. To remove a pulley from an intermediate shaft.
15. To remove from an intermediate shaft a sealing ring.
16. To unscrew two bolts of fastening of a basic flange of an intermediate shaft and to take an intermediate shaft.
17. To remove the pump of cooling liquid.
18. To remove the oil pallet.
19. To remove a pulley from a cranked shaft.
20. To remove a grid of a maslopriyemnik of the oil pump.
21. To designate and remove covers of rods.
22. After designation of rods to take them together with pistons from the block of cylinders of the engine.
23. To designate and remove covers of radical bearings.
24. To remove a cranked shaft.
25. To remove and designate loose leaves of radical bearings and persistent half rings of a cranked shaft.