Ford Sierra

1982-1993 of release

Repair and car operation

Ford Siyerra
+ 1.2. Car identification
+ 2. Maintenance
- 3. General data
   + 3.1. Cars with petrol engines
   - 3.2. Cars with diesel engines
      - 3.2.1. Changes in a car design from 1988 to 1993. Dm3 engine 2,3
         + Dm3 engine 1,8
         - Fuel system
   Fuel filter
   Removal and installation of nozzles
   Fuel pump
         + The repair which is not demanding removal of the engine Removal and engine installation Engine dismantling Check of details Check of gaps of a cranked shaft and rods Engine assembly Greasing system Cooling system Coupling Mechanical five-speed transmission of MT 75 type Power shaft and back bridge Steering system Forward suspension bracket Brake system Electric equipment General data
+ 4. Engines
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment Fuel system Fuel filter


System of injection of fuel

1–fuel pump,
2–proof-reader of an advancing of injection of the cold engine,
3–regulator of a dose of fuel,
4–electromagnetic valve of switching off
engine (STOP valve),
5–pipelines of injection,
7–pipeline of return of fuel,
8–washer of thermal isolation,
9–glow plug

Knot of the fuel filter

1–a replaced element of the filter,
2–arm of the filter,
3–drain bolt,
4–the pipeline connecting the filter to the fuel pump

Knot of the air filter

1–case of the filter,
2–a replaced element of the filter,
3–cover of the filter,
4–a branch pipe of supply of air to the filter,
5–a branch pipe of supply of air to a turbokompressor


1. To disconnect from the accumulator a weight wire.
2. Under the fuel filter to establish capacity for following fuel.
3. To unscrew an average bolt of fastening of the fuel filter, holding the filter and a glass settler.
4. To take a replaced element of the fuel filter.
5. To take laying of round section and laying of the top and lower part of the case of the filter.


1. To establish new laying of round section of a replaced element of the fuel filter and new laying of both parts of the case of the filter.
2. To insert a replaced element of the filter and a settler, slightly to screw in an average bolt and, having convinced that all elements are on the places, to tighten an average bolt.
3. To unscrew a bolt of removal of air from the filter and to pump up the manual pump while following fuel will not contain air vials.
4. To tighten a bolt of removal of air from the filter.
5. To connect to the accumulator a weight wire.
6. To start the engine and to check tightness of connections.
7. To clean capacity with the flowed-out fuel.