|
Ford Sierra1982-1993 of releaseRepair and car operation |
|
Ford Siyerra + 1.2. Car identification + 2. Maintenance + 3. General data + 4. Engines + 5. Coupling + 6. Transmissions - 7. Driveshaft and back bridge 7.1. Technical characteristics 7.2. Removal and driveshaft installation 7.3. Repair of the intermediate bearing 7.4. Removal and installation of the back bridge 7.5. Dismantling and assembly of the back bridge 7.6. Dismantling and differential assembly 7.7. Adjustment of bearings of gear wheels of the main transfer 7.8. Adjustment of gear wheels of the main transfer 7.9. Assembly and adjustment of the main transfer 7.10. Replacement of a sealing ring of a gear wheel of the main transfer + 7.11. Semi-axes + 8. Steering + 9. Suspension brackets + 10. Brake system + 11. Body + 12. Electric equipment |
7. Driveshaft and back bridge
Driveshaft The forward part of a shaft after installation is counterbalanced as a single whole. In case of a rassoyedineniye of parts of a shaft at their assembly it is necessary to pay attention to preservation of a relative positioning of adjusting signs (the deepenings executed by a center punch on a shaft, and also wide line on a crosspiece) which should lie on one line. Crosspieces of hinges have the needle bearings condensed for protection against pollution. Crosswise hinges form not folding knot which in case of need it is necessary to replace entirely with shaft. Zadny Bridge The gear wheel of the main transfer rotates in two conic bearings with the initial tightness realized by means of the being deformed remote plug. Adjustment of coupling of teeths of the main transfer is made by means of selection of thickness of laying between the internal bearing of a gear wheel and a gear wheel of the main transfer. Adjustment of a mezhzubyevy gap of the main transfer, and also initial tightness of bearings of differential is made by means of two adjusting flanges with ledges. Semi-axial gear wheels are established on shlitsa of a semi-axis and fixed by means of a lock ring. |
|