Ford Sierra

1982-1993 of release

Repair and car operation

Ford Siyerra
+ 1.2. Car identification
+ 2. Maintenance
+ 3. General data
- 4. Engines
   - 4.1. Petrol engines
      + 4.1.1. Technical characteristics
      4.1.2. Adjustment of gaps of valves
      + 4.1.3. Ignition system
      - 4.1.4. Fuel system
         + 4.1.4.1. The Ford carburetor with changeable section of a diffuzor
         - 4.1.4.2. Weber 32/36 DGAV carburetor
            4.1.4.2.1. Removal and carburetor installation
            4.1.4.2.2. Adjustment of provision of a float
            4.1.4.2.3. Adjustment of a starting zaslonka
            4.1.4.2.4. Check and adjustment of the automatic starting arrangement
            4.1.4.2.5. Adjustment of number of turns of idling of the engine and the contents WITH
      + 4.1.5. The repair which is not demanding removal of the engine
      4.1.6. Removal and engine installation
      4.1.7. Engine dismantling
      4.1.8. Identification of cooperating parts
      4.1.9. Engine assembly
      4.1.10. Replacement of pistons
      4.1.11. Removal and installation of an intermediate shaft
      4.1.12. Gazoraspredeleniye system
      4.1.13. Greasing system
      + 4.1.14. Cooling system
      4.1.15. Suspension bracket of the power unit
      4.1.16. System of production of the fulfilled gases
   + 4.2. Diesel engine
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

4.1.4.2.5. Adjustment of number of turns of idling of the engine and the contents WITH

GENERAL INFORMATION

Adjustment of idling of the Weber carburetor

1–screw of adjustment of number of turns of the engine,

2–casing of the screw of adjustment of structure of a mix

PERFORMANCE ORDER

1. To warm up the engine to normal working temperature.

2. To connect the analyzer of exhaust gases and a tachometer according to indications of the instruction on their application.

3. To hold in a current about 30 seconds number of turns of 3000 rpm, and then to release an accelerator pedal. To wait before installation of indications of the analyzer.

4. To check number of turns of idling of the engine. In case of need to adjust number of turns of the engine by means of the screw (1).

5. To read concentration indications WITH in exhaust gases. If concentration WITH small to remove a casing of the screw of adjustment of structure of a mix (2) and to adjust this screw concentration FROM idling engine.

6. Repeatedly to check number of turns of idling of the engine and in case of need to adjust.