Ford Sierra

1982-1993 of release

Repair and car operation

Ford Siyerra
+ 1.2. Car identification
+ 2. Maintenance
+ 3. General data
- 4. Engines
   - 4.1. Petrol engines
      + 4.1.1. Technical characteristics
      4.1.2. Adjustment of gaps of valves
      + 4.1.3. Ignition system
      - 4.1.4. Fuel system
         + 4.1.4.1. The Ford carburetor with changeable section of a diffuzor
         - 4.1.4.2. Weber 32/36 DGAV carburetor
            4.1.4.2.1. Removal and carburetor installation
            4.1.4.2.2. Adjustment of provision of a float
            4.1.4.2.3. Adjustment of a starting zaslonka
            4.1.4.2.4. Check and adjustment of the automatic starting arrangement
            4.1.4.2.5. Adjustment of number of turns of idling of the engine and the contents WITH
      + 4.1.5. The repair which is not demanding removal of the engine
      4.1.6. Removal and engine installation
      4.1.7. Engine dismantling
      4.1.8. Identification of cooperating parts
      4.1.9. Engine assembly
      4.1.10. Replacement of pistons
      4.1.11. Removal and installation of an intermediate shaft
      4.1.12. Gazoraspredeleniye system
      4.1.13. Greasing system
      + 4.1.14. Cooling system
      4.1.15. Suspension bracket of the power unit
      4.1.16. System of production of the fulfilled gases
   + 4.2. Diesel engine
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

www.weplancul.com

4.1.4.2.4. Check and adjustment of the automatic starting arrangement

GENERAL INFORMATION

The provision of elements of management by starting zaslonka at adjustment of the automatic starting arrangement of the Weber carburetor

And – a drill, In – a plate

PERFORMANCE ORDER

1. Partially to open a butterfly valve of a mix and to turn a cam of the accelerated idling so that the adjusting screw concerned its top.

2. To release a pedal of an accelerator and to block a cam in this situation.

3. To close a starting zaslonka while the emphasis of a cam will not rest against the adjusting screw of the accelerated idling.

4. Holding a starting zaslonka in a closed position, to measure width of a gap between edge of a butterfly valve and a wall of the air chamber. For measurement to use a core or a drill of the corresponding diameter.

5. In case of inappropriate size of a gap to adjust it, pressing a plate (In).

Adjustment of the raised number of turns of idling of the engine

PERFORMANCE ORDER

1. To connect to the engine a tachometer.

2. To warm up the engine to normal working temperature and to release an accelerator pedal.

3. At the working engine to hold a starting zaslonka in vertical situation (complete opening) and to turn the lever of the starting arrangement to its delay the mechanism of the accelerated idling.

4. To measure number of turns of the engine and in case of need to adjust it by turn of the adjusting screw of number of turns of the accelerated idling.