Ford Sierra

1982-1993 of release

Repair and car operation



Ford Siyerra
+ 1.2. Car identification
+ 2. Maintenance
+ 3. General data
- 4. Engines
   - 4.1. Petrol engines
      + 4.1.1. Technical characteristics
      4.1.2. Adjustment of gaps of valves
      + 4.1.3. Ignition system
      - 4.1.4. Fuel system
         + 4.1.4.1. The Ford carburetor with changeable section of a diffuzor
         - 4.1.4.2. Weber 32/36 DGAV carburetor
            4.1.4.2.1. Removal and carburetor installation
            4.1.4.2.2. Adjustment of provision of a float
            4.1.4.2.3. Adjustment of a starting zaslonka
            4.1.4.2.4. Check and adjustment of the automatic starting arrangement
            4.1.4.2.5. Adjustment of number of turns of idling of the engine and the contents WITH
      + 4.1.5. The repair which is not demanding removal of the engine
      4.1.6. Removal and engine installation
      4.1.7. Engine dismantling
      4.1.8. Identification of cooperating parts
      4.1.9. Engine assembly
      4.1.10. Replacement of pistons
      4.1.11. Removal and installation of an intermediate shaft
      4.1.12. Gazoraspredeleniye system
      4.1.13. Greasing system
      + 4.1.14. Cooling system
      4.1.15. Suspension bracket of the power unit
      4.1.16. System of production of the fulfilled gases
   + 4.2. Diesel engine
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment





4.1.4.2.2. Adjustment of provision of a float

GENERAL INFORMATION

Adjustment of provision of a float of the Weber carburetor

And = 41 ± 0,5 mm.


PERFORMANCE ORDER
1. To disconnect the accumulator and to remove the air filter.
2. To disconnect from the carburetor the pipeline of supply of fuel.
3. To pick up a screw-driver a clamp and to disconnect draft of management of a starting butterfly valve from the lever of an axis of a starting butterfly valve.
4. To unscrew six screws and to uncover the carburetor.
5. To establish a carburetor cover vertically with a float directed down.
6. To measure distance from the bottom surface of a float to the cover plane without laying. It should make 41±0,5 mm. In case of need to adjust it, bending down a plate on the top surface of a float.
7. To establish a carburetor cover together with new laying.
8. To connect the pipeline of supply of fuel and draft of management of an air zaslonka.