Ford Sierra

1982-1993 of release

Repair and car operation



Ford Siyerra
+ 1.2. Car identification
+ 2. Maintenance
+ 3. General data
- 4. Engines
   - 4.1. Petrol engines
      + 4.1.1. Technical characteristics
      4.1.2. Adjustment of gaps of valves
      + 4.1.3. Ignition system
      - 4.1.4. Fuel system
         + 4.1.4.1. The Ford carburetor with changeable section of a diffuzor
         - 4.1.4.2. Weber 32/36 DGAV carburetor
            4.1.4.2.1. Removal and carburetor installation
            4.1.4.2.2. Adjustment of provision of a float
            4.1.4.2.3. Adjustment of a starting zaslonka
            4.1.4.2.4. Check and adjustment of the automatic starting arrangement
            4.1.4.2.5. Adjustment of number of turns of idling of the engine and the contents WITH
      + 4.1.5. The repair which is not demanding removal of the engine
      4.1.6. Removal and engine installation
      4.1.7. Engine dismantling
      4.1.8. Identification of cooperating parts
      4.1.9. Engine assembly
      4.1.10. Replacement of pistons
      4.1.11. Removal and installation of an intermediate shaft
      4.1.12. Gazoraspredeleniye system
      4.1.13. Greasing system
      + 4.1.14. Cooling system
      4.1.15. Suspension bracket of the power unit
      4.1.16. System of production of the fulfilled gases
   + 4.2. Diesel engine
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment






4.1.4.2.1. Removal and carburetor installation

Removal

PERFORMANCE ORDER
1. To disconnect the accumulator and to remove the air filter.
2. Being careful, to unscrew a stopper of a broad tank.
3. From the starting arrangement to remove hoses of cooling liquid and to muffle them.
4. To disconnect a cable of management of a butterfly valve.
5. To remove a hose of supply of fuel to the carburetor.
6. To remove from the carburetor a vacuum hose from the ignition distributor.
7. To unscrew 4 fixing nuts and to remove the carburetor.
8. An opening of an inlet collector to close rags.

Installation

PERFORMANCE ORDER
1. Installation of the carburetor is made in sequence of return to removal.
2. After installation it is necessary to check: level of cooling liquid and the maintenance of an oxide of carbon and also to adjust idling turns.