Ford Sierra

1982-1993 of release

Repair and car operation

Ford Siyerra
+ 1.2. Car identification
+ 2. Maintenance
+ 3. General data
- 4. Engines
   - 4.1. Petrol engines
      + 4.1.1. Technical characteristics
      4.1.2. Adjustment of gaps of valves
      + 4.1.3. Ignition system
      - 4.1.4. Fuel system
         - 4.1.4.1. The Ford carburetor with changeable section of a diffuzor
            4.1.4.1.1. Removal and carburetor installation
            4.1.4.1.2. Dismantling, check and carburetor assembly
            4.1.4.1.3. Adjustment of number of turns of idling of the engine and the contents WITH
            4.1.4.1.4. Adjustment of the starting arrangement
            4.1.4.1.5. Adjustment of a cable of a butterfly valve
            4.1.4.1.6. Removal and installation of a needle shaft
            4.1.4.1.7. Diaphragm of a vacuum regulator
         + 4.1.4.2. Weber 32/36 DGAV carburetor
      + 4.1.5. The repair which is not demanding removal of the engine
      4.1.6. Removal and engine installation
      4.1.7. Engine dismantling
      4.1.8. Identification of cooperating parts
      4.1.9. Engine assembly
      4.1.10. Replacement of pistons
      4.1.11. Removal and installation of an intermediate shaft
      4.1.12. Gazoraspredeleniye system
      4.1.13. Greasing system
      + 4.1.14. Cooling system
      4.1.15. Suspension bracket of the power unit
      4.1.16. System of production of the fulfilled gases
   + 4.2. Diesel engine
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

4.1.4.1.4. Adjustment of the starting arrangement

GENERAL INFORMATION

Case of a bimetallic spring of the automatic starting arrangement of the Ford carburetor

The arrow showed adjusting signs for adjustment of time of operation of the starting arrangement (sign coincidence on the case of a bimetallic spring with the motionless sign first on the left side designates earlier switching off of the starting arrangement).

PERFORMANCE ORDER

1. To disconnect the accumulator and to remove the air filter.

2. To unscrew three screws with a crosswise head of fastening of the case of a bimetallic spring and to remove the case of the starting arrangement.

3. To remove a cap from the lower part of the case.

4. To turn a control lever of the starting arrangement so that the opening in its axis was opposite to an opening in the case.

5. To check correctness of situation through an opening in a casing.

6. To insert a drill of the corresponding diameter into an opening of a casing and to be convinced that it enters into an opening in axes of the starting arrangement.

7. To weaken a nut on an axis of the operating lever.

8. Without taking a drill, to turn against the stop clockwise the lever of the starting arrangement and довинтить a nut on its axis.

9. To take a drill and to check a gap, and also number of turns of idling of the engine as follows. To turn the lever of the starting arrangement so that an opening in its axis was opposite to an opening in the case.

10. To insert a drill of the corresponding diameter into the calibrated opening of the device and to check, whether it enters deep into lever axes.