Ford Sierra

1982-1993 of release

Repair and car operation



Ford Siyerra
+ 1.2. Car identification
+ 2. Maintenance
+ 3. General data
- 4. Engines
   - 4.1. Petrol engines
      + 4.1.1. Technical characteristics
      4.1.2. Adjustment of gaps of valves
      + 4.1.3. Ignition system
      - 4.1.4. Fuel system
         - 4.1.4.1. The Ford carburetor with changeable section of a diffuzor
            4.1.4.1.1. Removal and carburetor installation
            4.1.4.1.2. Dismantling, check and carburetor assembly
            4.1.4.1.3. Adjustment of number of turns of idling of the engine and the contents WITH
            4.1.4.1.4. Adjustment of the starting arrangement
            4.1.4.1.5. Adjustment of a cable of a butterfly valve
            4.1.4.1.6. Removal and installation of a needle shaft
            4.1.4.1.7. Diaphragm of a vacuum regulator
         + 4.1.4.2. Weber 32/36 DGAV carburetor
      + 4.1.5. The repair which is not demanding removal of the engine
      4.1.6. Removal and engine installation
      4.1.7. Engine dismantling
      4.1.8. Identification of cooperating parts
      4.1.9. Engine assembly
      4.1.10. Replacement of pistons
      4.1.11. Removal and installation of an intermediate shaft
      4.1.12. Gazoraspredeleniye system
      4.1.13. Greasing system
      + 4.1.14. Cooling system
      4.1.15. Suspension bracket of the power unit
      4.1.16. System of production of the fulfilled gases
   + 4.2. Diesel engine
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment






4.1.4.1.1. Removal and carburetor installation

Removal

PERFORMANCE ORDER
1. To remove the air filter.
2. To disconnect from the carburetor elastic the pipeline: supply of fuel and heating (liquid cooling the engine) the automatic starting arrangement and to close their openings the corresponding caps.
3. To disconnect from the carburetor the socket of an electric wire of the electromagnetic valve.
4. To disconnect from the butterfly valve lever a cable of a pedal of an accelerator.
5. To unscrew nuts of fastening of the carburetor to an inlet collector and to remove them together with washers.
6. To remove the carburetor from an inlet collector to cover with rags an opening of an inlet collector.

Installation

PERFORMANCE ORDER
1. Actions on installation of the carburetor are carried out in sequence of return to process of its removal.
2. After installation of the carburetor it is necessary to adjust a cable of a pedal of an accelerator, to remove air from system of cooling and to adjust number of turns of idling and the contents WITH (mix structure).