Ford Sierra

1982-1993 of release

Repair and car operation



Ford Siyerra
+ 1.2. Car identification
+ 2. Maintenance
+ 3. General data
- 4. Engines
   - 4.1. Petrol engines
      + 4.1.1. Technical characteristics
      4.1.2. Adjustment of gaps of valves
      - 4.1.3. Ignition system
         4.1.3.1. The sensor of impulses with the Hall converter
         4.1.3.2. To distribute ignitions
         4.1.3.3. Switchboard
         4.1.3.4. Remarks on operation
         4.1.3.5. Installation of a corner of an advancing of ignition
         4.1.3.6. Determination of malfunctions
         4.1.3.7. Removal and installation of the distributor of ignition
      + 4.1.4. Fuel system
      + 4.1.5. The repair which is not demanding removal of the engine
      4.1.6. Removal and engine installation
      4.1.7. Engine dismantling
      4.1.8. Identification of cooperating parts
      4.1.9. Engine assembly
      4.1.10. Replacement of pistons
      4.1.11. Removal and installation of an intermediate shaft
      4.1.12. Gazoraspredeleniye system
      4.1.13. Greasing system
      + 4.1.14. Cooling system
      4.1.15. Suspension bracket of the power unit
      4.1.16. System of production of the fulfilled gases
   + 4.2. Diesel engine
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment





4.1.3.4. Remarks on operation

GENERAL INFORMATION

The transistor system of ignition possesses bigger energy in a chain of a high voltage, than classical system of ignition.

In operating time of the engine it is impossible to concern elements of transistor system of ignition, especially wires of a high voltage.

Before all operations connected with replacement of elements of system of ignition, it is necessary to disconnect the accumulator from car electric equipment.
It is impossible to connect the condenser to the plug of 1 coil of ignition.

It is impossible to connect the plug (+) the accumulator to the plug of 1 coil of ignition as it threatens with switchboard damage.

During check of pressure of compression in cylinders of the engine it is necessary to disconnect the switchboard or to connect the plug of 4 coils of ignition to mass of the car.