Ford Sierra

1982-1993 of release

Repair and car operation


Ford Siyerra
+ 1.2. Car identification
+ 2. Maintenance
+ 3. General data
+ 4. Engines
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
- 12. Electric equipment
   12.1. Technical characteristics
   12.2. Relay and safety locks
   12.3. Removal and generator installation
   12.4. Dismantling and generator assembly
   12.5. Adjustment of a tension of a maple belt
   12.6. Starter
   12.7. Windscreen screen wiper, knot of indexes and headlight
   12.8. Removal and installation of a combination of devices
   12.9. Adjustment of light of headlights
   + 12.10. Heating and ventilation system
   + 12.11. Electroschemes


https://www.magicalescorts.com/



12.6. Starter
GENERAL INFORMATION

Starter fastening

1–bolts of fastening of a starter to a case of coupling,

2–wire of power supply of a starter,

3–wire of power supply of the electromagnetic switch


Lucas starters

 
1–head,
2–knot of a drive,
3–lever of a drive,
4–electromagnetic switch,

5–stator,
6–rotor,
7–a back cover with a shchetkoderzhatel

Cajavec and Nippondenso starters

 
And – Cajavec Starters
1–head,
2–knot of a drive,
3–lever of a drive,
4–electromagnetic switch,
5–stator,
6–rotor,
7–shchetkoderzhatel
 In – Nippondenso Starters
1–head,
2–knot of a drive,
3–lever of a drive,
4–electromagnetic switch,
5–stator,
6–rotor,
7–shchetkoderzhatel

Bosch starters

 
1–head,
2–knot of a drive,
3–lever of a drive,

4–electromagnetic switch,
5–stator,
6–rotor,
7–shchetkoderzhatel


REMOVAL AND STARTER INSTALLATION

Removal
PERFORMANCE ORDER
1. To disconnect a wire of weight of the accumulator.
2. To lift and fix in front of the car.
3. To disconnect from a starter the main wire of power supply, and also an electric wire from the electromagnetic switch of a starter.
4. To unscrew three bolts of fastening (see fig. Starter fastening) and to take a starter from below the car.

Installation

For installation of a starter it is necessary to execute actions in return sequence in relation to removal process.

DISMANTLING AND STARTER ASSEMBLY

For dismantling and starter assembly after its removal from the car it is necessary to use drawings: Lucas starters, Cajavec and Nippondenso Starters and Bosch Starters on which the correct provisions of each detail are presented.

After dismantling of a starter it is necessary to check:

  – a condition of brushes, their wear, and also freedom of moving of brushes in shchetkoderzhatel;
  – force of a clip and provision of springs of brushes;
  – a type of a collector which should be cleared a rag moistened in gasoline or трихлорэтилене, and прошлифовать a fine-grained emery paper;
  – a condition of plugs of self-greased bearings; in case of need replacements should be lowered new plugs not less, than for 20 minutes in engine oil (viscosity of SAE 30 or 40) before their installation in a starter.