Ford Siyerra
+ 1.2. Car identification
+ 2. Maintenance
+ 3. General data
+ 4. Engines
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
- 12. Electric equipment
12.1. Technical characteristics
12.2. Relay and safety locks
12.3. Removal and generator installation
12.4. Dismantling and generator assembly
12.5. Adjustment of a tension of a maple belt
12.6. Starter
12.7. Windscreen screen wiper, knot of indexes and headlight
12.8. Removal and installation of a combination of devices
12.9. Adjustment of light of headlights
+ 12.10. Heating and ventilation system
+ 12.11. Electroschemes
|
Generator removal
|
|
1–connection of wires,
2–bottom bolts of fastening
|
Removal
| PERFORMANCE ORDER |
| 1. To disconnect a weight wire from the accumulator, and also the socket of multicontact connection behind the generator (after removal of a safety fastener). |
| 2. To weaken bolts of fastening of the generator. |
| 3. To turn the generator to the engine and to remove maple a belt from a generator pulley. |
| 4. To unscrew bolts of fastening and to take the generator. |
|
Installation
| PERFORMANCE ORDER |
| 1. To insert the generator, to screw up bolts of its fastening and to tighten them a hand. |
| 2. To connect and fix the socket of multicontact connection of wires behind the generator. |
|
3. To establish and pull maple a belt (1 – a bolt of the tension device, And – a belt deflection (And = 10 mm)). |
| 4. To tighten a bolt of adjustment of a tightness, then a forward bolt of the bottom fastening and, at last, a back bolt of the bottom fastening of the generator. |
| 5. To connect a weight wire to the accumulator. |
| 6. To check a tension of a maple belt. In case of need to weaken bolts of fastening of the generator, to pull maple a belt and again to tighten bolts, since a bolt of adjustment of a tightness, and then a bolt of forward and back fastening of the generator. |
|
|
|