Ford Siyerra
+ 1.2. Car identification
+ 2. Maintenance
+ 3. General data
+ 4. Engines
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
- 12. Electric equipment
12.1. Technical characteristics
12.2. Relay and safety locks
12.3. Removal and generator installation
12.4. Dismantling and generator assembly
12.5. Adjustment of a tension of a maple belt
12.6. Starter
12.7. Windscreen screen wiper, knot of indexes and headlight
12.8. Removal and installation of a combination of devices
12.9. Adjustment of light of headlights
- 12.10. Heating and ventilation system
12.10.1. Removal and heater installation
12.10.2. Fan engine
+ 12.11. Electroschemes
|
System of heating and car ventilation
|
|
1–heater,
2–case of a heater,
3–air zaslonka,
4–knot of management,
5–case of the fan,
6–fans
|
Heater case
|
|
1–nut of fastening,
2–heater,
3–bells of supply of air
|
Removal
| PERFORMANCE ORDER |
| 1. To disconnect a weight wire from the accumulator. |
| 2. In a compartment of the engine to establish spring clips on the elastic pipelines of cooling liquid connected to a heater. |
| 3. To disconnect a cover and consolidations of air pipelines. |
| 4. To remove the average console of the forward panel together with a ware box (fastening by six bolts). |
| 5. To remove control lever brackets heating on the forward panel and to unscrew the control lever case (three screws), to move it down and to disconnect electric wires. |
| 6. To disconnect from heating knot air bells. |
| 7. To disconnect on the left side two cables of management of supply of air. |
| 8. To unscrew nuts of fastening of knot of heating and to take it. |
|
Installation
| PERFORMANCE ORDER |
| For installation of knot of heating it is necessary to execute actions in return sequence in relation to removal process. Before installation of facing of a floor it is necessary to adjust a cable of management of supply of air. After installation of a heater it is necessary to remove air from system of cooling of the engine and to fill amount of cooling liquid to necessary level. |
|
|
|