Ford Sierra

1982-1993 of release

Repair and car operation



Ford Siyerra
+ 1.2. Car identification
+ 2. Maintenance
+ 3. General data
+ 4. Engines
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
- 9. Suspension brackets
   - 9.1. Forward suspension bracket
      9.1.1. Technical characteristics
      9.1.2. Removal and installation of a rack of a forward suspension bracket
      9.1.3. Dismantling and assembly of a rack of a suspension bracket
      9.1.4. Removal and stabilizer installation
      9.1.5. Replacement of the metallo-rubber plug of the lever
      9.1.6. Removal and installation of a rotary fist
      9.1.7. Check of installation of forward wheels
      9.1.8. Replacement of bearings of a nave of a forward wheel
   + 9.2. Back suspension bracket
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment






9.1.8. Replacement of bearings of a nave of a forward wheel

GENERAL INFORMATION

Nave of a forward wheel in a cut

1–conic bearings,

2–sealing ring

PERFORMANCE ORDER
1. To remove a rotary fist of a wheel (see the corresponding description in subsection 9.1.6).
2. To put the clamps (conic surfaces outside) on bolts of fastening the wheels located in a nave, and to fix in vice rotary fist together with nave, holding for nuts of wheels.
3. To remove a protective cap of an axis of a wheel from the interior of a rotary fist.
4. To unscrew a nut of an axis of a wheel and to take flat laying.
5. To take the internal conic bearing from a rotary fist.
6. To remove a rotary fist from a wheel nave.
7. To extend a sealing ring by means of the adaptation 21.051.
8. To beat out external rings of conic bearings by means of a core from bronze.
9. To clear and check a technical condition of the taken details. To replace the worn-out or damaged details.
10. To insert by means of the adaptation 14.024 new external rings of bearings into the rotary fist as which emphasis wooden whetstone serves.
11. To fill all space between bearings firm greasing for bearings.
12. To establish the external bearing and to press a new sealing ring with space between sealing edges filled with firm greasing.
13. To establish a rotary fist on a wheel nave.
14. To establish the internal conic bearing, to insert flat laying and to tighten new самоконтрящуюся a nut of a nave of a wheel the corresponding moment (see subsection 9.1.1)
15. To establish a protective cap of an axis of a wheel from the interior of a rotary fist.
16. To remove a rotary fist from a vice and to unscrew nuts from bolts of fastening of a wheel.

17. To establish a rotary fist on the car.