Ford Siyerra + 1.2. Car identification + 2. Maintenance + 3. General data + 4. Engines + 5. Coupling + 6. Transmissions + 7. Driveshaft and back bridge + 8. Steering - 9. Suspension brackets - 9.1. Forward suspension bracket 9.1.1. Technical characteristics 9.1.2. Removal and installation of a rack of a forward suspension bracket 9.1.3. Dismantling and assembly of a rack of a suspension bracket 9.1.4. Removal and stabilizer installation 9.1.5. Replacement of the metallo-rubber plug of the lever 9.1.6. Removal and installation of a rotary fist 9.1.7. Check of installation of forward wheels 9.1.8. Replacement of bearings of a nave of a forward wheel + 9.2. Back suspension bracket + 10. Brake system + 11. Body + 12. Electric equipment
|
Forward suspension bracket
1–knot of the top fastening of a rack of a suspension bracket, 2–basic bearing, 3–spring of a suspension bracket, 4–shock-absorber, 5–rotary fist, 6–the lever with the spherical hinge, |
7–stabilizer, 8–nave of a wheel, 9–bearings of a nave, 10-nut of a nave, 11-cap, 12-metallo-rubber plug |
Removal
PERFORMANCE ORDER |
1. To weaken nuts of fastening of a wheel from the relevant party of the car. |
2. To lift and prop up in front of the car and to remove forward wheels. |
3. By means of a jack to prop up the hinge of the cross-section lever. |
4. To unscrew bolts of fastening of a rack of a suspension bracket to a rotary fist of a wheel. |
|
5. Into cut of a rotary fist to insert the adaptation 14.026 and to turn it on 90 °, weakening the bottom fastening of a rack of a suspension bracket. |
6. To press down a rotary fist the suspension bracket rack will not be released yet, paying attention not to damage a brake hose. |
7. To suspend a rotary fist to a body so that it did not concern brake hoses. |
8. In a motor compartment to unscrew a plastic casing of the top fastening of a rack of a suspension bracket. |
9. Blocking a shock-absorber rod a key for six-sided nests of 6 mm and holding a suspension bracket rack that it did not drop out (it is necessary the help of other person), to unscrew a nut of the top fastening of a rack to a body. |
10. To take in the direction down a suspension bracket rack |
|
Installation
PERFORMANCE ORDER |
1. To establish a suspension bracket rack on the corresponding place. |
2. To insert the top laying and a nut of the top fastening of a rack of a suspension bracket. |
|
3. To check a centering of a rod of the shock-absorber concerning a body and to tighten a nut of the top fastening, holding a rod with a key for six-sided nests of 6 mm. |
|
4. To insert the adaptation 14.026 into a groove of a rotary fist and to turn it on 90 °. |
5. To establish the lower part of a rack in a rotary fist. |
6. To remove the adaptation 14.026. |
7. To screw up a bolt of fastening of a rack to a rotary fist of a wheel and to tighten it the corresponding moment. |
8. To screw wheels, to lower the car and to tighten nuts of wheels the corresponding moment. |
9. To check a convergence of forward wheels. |
|
|
|