Ford Sierra

1982-1993 of release

Repair and car operation



Ford Siyerra
+ 1.2. Car identification
+ 2. Maintenance
+ 3. General data
+ 4. Engines
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
- 9. Suspension brackets
   - 9.1. Forward suspension bracket
      9.1.1. Technical characteristics
      9.1.2. Removal and installation of a rack of a forward suspension bracket
      9.1.3. Dismantling and assembly of a rack of a suspension bracket
      9.1.4. Removal and stabilizer installation
      9.1.5. Replacement of the metallo-rubber plug of the lever
      9.1.6. Removal and installation of a rotary fist
      9.1.7. Check of installation of forward wheels
      9.1.8. Replacement of bearings of a nave of a forward wheel
   + 9.2. Back suspension bracket
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment





9.1.6. Removal and installation of a rotary fist

GENERAL INFORMATION

Fastening of a rotary fist of a wheel


1–bolt of the bottom fastening of the shock-absorber,

2–nut of fastening of steering draft,

3–nut of fastening of the stabilizer

Removal
PERFORMANCE ORDER
1. To weaken from the relevant party of a nut of a forward wheel.
2. To lift and prop up the car and to remove a forward wheel.
3. To remove a brake support without a detachment of hydraulic pipelines and to suspend it to a body by means of a soft wire.
4. To unscrew the screw of fastening of a brake disk and to remove a disk.
5. To take шплинты and to unscrew koronchaty nuts of spherical hinges from a rotary fist.
6. To squeeze out from a rotary fist the spherical hinge of steering draft by means of the adaptation 13.006.
7. To squeeze out the spherical hinge of the cross-section lever from a rotary fist by means of a stripper.
8. To unscrew from a rotary fist tightening a bolt of the bottom fastening of a rack of a suspension bracket.
9. To disconnect a suspension bracket rack from a rotary fist by means of the adaptation 14.026 and to take a rotary fist.

Installation

For installation of a rotary fist it is necessary to execute actions in return sequence in relation to removal process.