Ford Siyerra + 1.2. Car identification + 2. Maintenance + 3. General data + 4. Engines + 5. Coupling + 6. Transmissions - 7. Driveshaft and back bridge 7.1. Technical characteristics 7.2. Removal and driveshaft installation 7.3. Repair of the intermediate bearing 7.4. Removal and installation of the back bridge 7.5. Dismantling and assembly of the back bridge 7.6. Dismantling and differential assembly 7.7. Adjustment of bearings of gear wheels of the main transfer 7.8. Adjustment of gear wheels of the main transfer 7.9. Assembly and adjustment of the main transfer 7.10. Replacement of a sealing ring of a gear wheel of the main transfer + 7.11. Semi-axes + 8. Steering + 9. Suspension brackets + 10. Brake system + 11. Body + 12. Electric equipment
|
Measurement of an axial gap between semi-axial gear wheels and a differential box
|
Dismantling of differential is obligatory only when the gap between semi-axial gear wheels and a box of differential exceeds value of 0,15 mm or when satellites or semi-axial gear wheels are damaged. |
Dismantling
PERFORMANCE ORDER |
1. By means of the adaptation 15.026 A to remove bearings of a box of differential. |
2. To establish a differential box in a vice, to weaken bolts of fastening of a conducted gear wheel of the main transfer and to separate a gear wheel with a box, carefully striking in fastening bolts. |
3. To unscrew bolts of fastening and to remove a gear wheel from a differential box. |
4. To take an adjusting pin of an axis of satellites. |
5. To take an axis, satellites and their adjusting laying. |
|
Assembly
PERFORMANCE ORDER |
1. To establish semi-axial gear wheels together with new adjusting laying with a thickness picked up according to earlier measured gaps. |
2. To establish satellites together with basic laying and an axis. |
3. To heat up a conducted gear wheel of the main transfer (by its lowering in hot water) and to put on it a differential box. To provide a normal centering with a way of installation of four bolts of fastening. |
4. After adjustment of installation of gear wheels of the main transfer (see subsection 7.8) to establish differential bearings. |
|
|
|