Ford Siyerra + 1.2. Car identification + 2. Maintenance + 3. General data + 4. Engines + 5. Coupling + 6. Transmissions - 7. Driveshaft and back bridge 7.1. Technical characteristics 7.2. Removal and driveshaft installation 7.3. Repair of the intermediate bearing 7.4. Removal and installation of the back bridge 7.5. Dismantling and assembly of the back bridge 7.6. Dismantling and differential assembly 7.7. Adjustment of bearings of gear wheels of the main transfer 7.8. Adjustment of gear wheels of the main transfer 7.9. Assembly and adjustment of the main transfer 7.10. Replacement of a sealing ring of a gear wheel of the main transfer + 7.11. Semi-axes + 8. Steering + 9. Suspension brackets + 10. Brake system + 11. Body + 12. Electric equipment
|
Driveshaft and driving semi-axes
1–shaft assembled, 2–elastic hinge, 3–intermediate bearing, 4–driving semi-axes,
|
5–equipotential three-humeral hinge, 6–safety covers, 7–nut of a nave of a wheel |
Forward hinge of the driveshaft
|
And – cars with the engine 1,3 of dm3,
In – cars with dm3 engines 1,6 and 2,0 |
Removal
PERFORMANCE ORDER |
1. To establish the car over the viewing channel or on the lift. |
2. To designate mutual position of the crosswise hinge and a flange of a gear wheel of the main transfer and to disconnect the driveshaft from the back bridge. To unscrew the case of the intermediate bearing, having designated the provision of laying between the case of the bearing and a car body (these designations will be useful at installation of the driveshaft and its intermediate bearing). |
3. To disconnect the driveshaft from a transmission, paying attention not to damage a sealing ring in a back part of a case. After shaft extraction the opening in a back part of a case of a transmission should be muffled a stopper or a forward tip of the faulty driveshaft not to allow an oil effluence from a transmission. |
|
Installation
PERFORMANCE ORDER |
1. From an opening of a back part of a case of a transmission to take a stopper. To check installation of a sealing ring of a back part of a case of a transmission and to insert into it the forward end of the driveshaft, paying attention not to damage an edge of a sealing ring. |
2. To establish the intermediate bearing of the driveshaft, having arranged under it the corresponding laying according to the designations put during dismantling (without tightening fastening bolts). |
3. To connect the driveshaft to a flange of a leading gear wheel of the main transfer according to the designations of a relative positioning put earlier. To establish the new laying protecting bolts from unscrewing. |
4. Rotating the driveshaft to establish the intermediate bearing and to tighten bolts of fastening the corresponding moment. |
5. To check and in case of need to add amount of oil in a transmission. |
|
|
|