Ford Sierra

1982-1993 of release

Repair and car operation



Ford Siyerra
+ 1.2. Car identification
+ 2. Maintenance
+ 3. General data
- 4. Engines
   + 4.1. Petrol engines
   - 4.2. Diesel engine
      + 4.2.1. Technical characteristics
      4.2.2. Check and adjustment of gaps of valves
      + 4.2.3. Fuel system
      + 4.2.4. Nozzles
      4.2.5. Glow plugs
      4.2.6. Compression check
      4.2.7. Air removal from fuel system
      4.2.8. Fuel filter
      4.2.9. Fuel pump, installation of the beginning of injection of fuel
      4.2.10. Adjustment of number of turns of idling
      - 4.2.11. The repair which is not demanding removal of the engine
         + 4.2.11.1. Head of the block of cylinders
         4.2.11.2. Removal and engine installation
         + 4.2.11.3. Dismantling, repair and engine assembly
         - 4.2.11.4. Greasing system
            4.2.11.4.1. Oil pump
            4.2.11.4.2. Check of pressure of oil
         + 4.2.11.5. Cooling system
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment






4.2.11.4. Greasing system

4.2.11.4.1. Oil pump

GENERAL INFORMATION

Greasing system

1–oil pump,
2–maslopriyemnik of the pump,
3–oil pallet,
4–drain stopper,
5–laying of the oil pallet,
6–holder of the oil filter,
7–sensor of pressure of oil,
8–oil radiator,
9–oil filter,
10-directing the index of level of oil,
11-index of level of oil,
12-gear wheel of a drive of the oil pump,
13-bolt of fastening of the oil pump

Oil pump

1–cover,

2–maslopriyemnik,

3–a shaft with a gear wheel,

4–case,

5–valve,

6–gear wheel

Removal

PERFORMANCE ORDER
1. To merge oil from the engine.
2. To disconnect from the accumulator a wire of weight and to remove the air filter.
3. To take the top sheet casing of a radiator and to disconnect two holders of an engine mount.
4. To hold the engine by means of the lift (adaptation 21.060).
5. To unscrew bolts and to remove the oil pallet.
6. To unscrew a stopper on the case of the oil pump.
7. To unscrew a nut with the muffled opening, to take a washer; to unscrew a bolt of fastening of the oil pump and to take it together with a washer.
8. To take from within the block of cylinders the oil pump 1 (2 – a power shaft of the pump).

Installation

PERFORMANCE ORDER
1. To establish the oil pump in the block of cylinders of the engine so that the konusny opening was in its case opposite to an opening with a carving for a fastening bolt.
2. To establish a copper washer, to tighten a bolt of fastening of the oil pump and a nut with the muffled opening together with a washer.
3. To measure width of a gap between stopper surfaces with a carving and the block of cylinders of the engine.
4. To establish a washer in thickness of 0,05-0,10 mm for providing the corresponding working gap.
5. Other actions to execute in return sequence in relation to process of removal of the oil pump.