Ford Sierra

1982-1993 of release

Repair and car operation



Ford Siyerra
+ 1.2. Car identification
+ 2. Maintenance
+ 3. General data
- 4. Engines
   + 4.1. Petrol engines
   - 4.2. Diesel engine
      + 4.2.1. Technical characteristics
      4.2.2. Check and adjustment of gaps of valves
      + 4.2.3. Fuel system
      + 4.2.4. Nozzles
      4.2.5. Glow plugs
      4.2.6. Compression check
      4.2.7. Air removal from fuel system
      4.2.8. Fuel filter
      4.2.9. Fuel pump, installation of the beginning of injection of fuel
      4.2.10. Adjustment of number of turns of idling
      + 4.2.11. The repair which is not demanding removal of the engine
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment






4.2.7. Air removal from fuel system

GENERAL INFORMATION

Air removal from fuel system
And – a deaerator,

R – the button of the manual fuel pump,

V–bolt of fastening of a settler

This procedure is necessary for carrying out surely in the following cases:

  – detachments of the fuel pipeline;
  – zavozdushivaniye of a fuel contour of the fuel pump;
  – engine switching off in the absence of fuel in a fuel tank;
  – replacements of the fuel filter.

PERFORMANCE ORDER
1. To weaken deaerator (And) filter fastening and a bolt (5 – see fig. System of injection of fuel) couplings of the pipeline of supply of fuel to the fuel pump.
2. Under a deaerator and the coupling of the pipeline to substitute capacity.
3. In the engines equipped with the manual fuel pump with a shaped polygonal head to unscrew a head of the manual fuel pump.
4. To press the button of the manual pump until the fuel following from a deaerator, will not contain air vials.
5. To tighten a deaerator of the fuel filter.
6. To press the button of the manual pump until the fuel following from under a bolt of the coupling of the weakened pipeline of supply of fuel to the fuel pump, will not contain vials of air and immediately to tighten a bolt of the coupling of this pipeline.
7. To stop supply of fuel when the button of the pump will start to show strong resistance. In the engines equipped with the manual fuel pump with a shaped head to tighten a hand a head of the fuel pump.
8. In case were replaced (or unscrewed) injection pipelines, it is necessary to weaken nuts of their fastening to nozzles to press an accelerator pedal against the stop and to include a starter while from under pipelines with the weakened fastening fuel will not start to pour out.
9. To screw pipelines of supply of fuel on nozzles and to start the engine.
10. To check tightness of all connections of fuel pipelines.