Ford Sierra

1982-1993 of release

Repair and car operation



Ford Siyerra
+ 1.2. Car identification
+ 2. Maintenance
+ 3. General data
+ 4. Engines
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
- 8. Steering
   8.1. Technical characteristics
   8.2. Removal and installation of steering transfer
   8.3. Dismantling and assembly of steering transfer
   8.4. Removal and installation of a steering column
   8.5. Dismantling and assembly of a steering wheel
   + 8.6. A steering with the hydraulic booster
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment






8.5. Dismantling and assembly of a steering wheel

Dismantling

PERFORMANCE ORDER
1. To clamp a steering column in a vice with soft cheeks.
2. To remove a casing from an artificial material from a nave of a steering wheel.
3. To unscrew a nut of fastening of a steering wheel.
4. To remove a cam of the switch of indexes of turn and laying of the top bearing of a shaft of a steering wheel.
5. To disconnect a shaft of a steering wheel from the being deformed plug.
6. By means of the corresponding lever to take the top and bottom bearings of a shaft of a steering wheel.
7. To take the bottom basic laying and a spring.
8. To take the bottom nylon ring of a shaft of a steering wheel.
9. To turn a key in the ignition lock in situation "1".
10. To press a clip and to take a drum of the blocking lock of a steering wheel.
11. To unscrew bolts of fastening of the switch of ignition and to take it together with a plait of electric wires.

Assembly

PERFORMANCE ORDER
1. To check a condition of elements of a steering column (see fig. A steering) and whether the site of a shaft of hexagonal section is covered with oil or greasing.
2. To clamp in a vice a shaft of a steering wheel, to establish on a shaft the bottom nylon ring at the corresponding distance (The X-th = 52 mm; Y= 189 ± 3 mm).
3. To establish bearings in the shaft plug.
4. To establish a spring and the bottom basic laying on a shaft.
5. To establish on a shaft the plug, the top basic laying and a cam of switching off of indexes of turn.
6. To establish on the shaft end a steering wheel, to tighten a nut of fastening and to establish a casing from an artificial material on a nave of a steering wheel.

Prevention

The distance between the welded laying of a shaft and the bottom bearing should make 12 ± 1 mm. In case this condition is not carried out, it is necessary to replace a shaft of a steering wheel.