Ford Sierra

1982-1993 of release

Repair and car operation



Ford Siyerra
+ 1.2. Car identification
+ 2. Maintenance
+ 3. General data
+ 4. Engines
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
- 8. Steering
   8.1. Technical characteristics
   8.2. Removal and installation of steering transfer
   8.3. Dismantling and assembly of steering transfer
   8.4. Removal and installation of a steering column
   8.5. Dismantling and assembly of a steering wheel
   + 8.6. A steering with the hydraulic booster
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment






8.3. Dismantling and assembly of steering transfer

Dismantling

PERFORMANCE ORDER
1. To disconnect tips with spherical hinges from steering drafts after weakening of fastening of lock-nuts.
2. To remove collars of fastening of casings and to remove protective a casing of the case of steering transfer.
3. To move a gear lath to the left against the stop and to clamp in a vice with soft cheeks.
4. The corresponding key to unscrew steering drafts from a gear lath.
5. To uncover a pusher a cover of steering transfer, to take laying, adjusting laying, a spring and a pusher.
6. To uncover a driving gear wheel of steering transfer together with its laying.
7. To remove the bearing from a shaft of a driving gear wheel of steering transfer.
8. To take a gear lath from the transfer case.
9. To take a nylon directing ring on the right side of the case of steering transfer.

Assembly

PERFORMANCE ORDER
1. To clear and check a technical condition of all details; to replace the worn-out or damaged details.
2. To insert into the case a nylon directing ring on the right side of the case of steering transfer.
3. To attach a gear lath to the case of steering transfer and to establish a lath on the average situation.
4. To establish a driving gear wheel in the case of steering transfer together with the bearing.
5. To insert laying and a cover of the case of a driving gear wheel.
6. To establish a pusher in the case of steering transfer.
7. To establish the indicator of hour type together with a bracket (15.046 and 13.008).
8. To establish on a razmetochny plate a sensor arrow on a zero.
9. To establish the sensor on a pusher, and its measuring tip to rest against the case of steering transfer.
10. To write down the indication (And) during moving of a gear lath from one extreme situation to another.
11. Thickness (Е) laying which it is necessary to establish under a pusher cover, are defined in millimeters on the basis of expression:
Е= AND J + F
where:
And – the indication of the sensor of display type;
j= 0,14 mm – thickness of laying;
F= 0,015... 0,150 mm – a constructive gap.
12. To establish a pusher spring, adjusting laying of the calculated thickness, laying, a cover and to tighten bolts of fastening of a cover.
13. By means of a dynamometer to check the resistance moment during turn of a driving gear wheel of steering transfer (see subsection 7.1).
14. To move a gear lath in the case against the stop to the left and to clamp in a vice with soft cheeks.
15. To connect steering bent for to a gear lath and to put on protective a casing of the case of transfer.
16. To establish new collars of fastening of casings.
17. To connect to steering drafts tips with spherical hinges and to fix them from unscrewing.