Ford Sierra

1982-1993 of release

Repair and car operation


Ford Siyerra
+ 1.2. Car identification
+ 2. Maintenance
+ 3. General data
- 4. Engines
   + 4.1. Petrol engines
   - 4.2. Diesel engine
      + 4.2.1. Technical characteristics
      4.2.2. Check and adjustment of gaps of valves
      + 4.2.3. Fuel system
      - 4.2.4. Nozzles
         4.2.4.1. Check of tightness of a spray of a nozzle
         4.2.4.2. Adjustment of initial pressure of injection
      4.2.5. Glow plugs
      4.2.6. Compression check
      4.2.7. Air removal from fuel system
      4.2.8. Fuel filter
      4.2.9. Fuel pump, installation of the beginning of injection of fuel
      4.2.10. Adjustment of number of turns of idling
      + 4.2.11. The repair which is not demanding removal of the engine
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment






4.2.4.2. Adjustment of initial pressure of injection
GENERAL INFORMATION

Torch of dispersion of fuel

Initial pressure of injection is regulated by laying installation under a spring. The increase in thickness of laying increases pressure of the beginning of injection, reduction – reduces. Change of thickness of laying approximately changes pressure of the beginning of injection upon 1 kg/cm2 to 0,01 mm.

Indispensable condition of work of a nozzle is quality of dispersion. The torch of dispersion should be uniform on all cross-section section of a cone of dispersion, and dispersion should be misty.

The beginning and the end of injection should be accurate. At new nozzles injection is accompanied by a sharp sound, At working nozzles lack of this sound is not a malfunction sign.