Ford Sierra

1982-1993 of release

Repair and car operation


Ford Siyerra
+ 1.2. Car identification
+ 2. Maintenance
+ 3. General data
+ 4. Engines
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
- 10. Brake system
   10.1. Technical characteristics
   + 10.2. Forward brakes
   + 10.3. Back brakes
   10.4. Removal and installation of the main brake cylinder
   10.5. Air removal from brake system
   10.6. Adjustment of the hand brake
+ 11. Body
+ 12. Electric equipment






10. Brake system

10.1. Technical characteristics
GENERAL INFORMATION

The working brake system is put in action hydraulically. In system the vacuum amplifier of brakes is used. The brake system consists of two contours. Forward brakes disk, and back – drum-type. The hand brake is put in action mechanically and puts in action back brakes.

Forward brakes

Forward brakes – disk. In them full disks and floating a support with one piston are used.

External diameter of a brake disk
240 mm
Thickness of a disk:
  – the nominal
12,65 mm
  – the minimum admissible
11,3 mm
Maximum disk palpation
0,15 mm
Diameter of the cylinder of a support
54,0 mm
Type of brake shoes
Girling D of 600 FF
Sizes of blocks
38 x 111 mm
Thickness of slips (without a basis plate):
  – the nominal
12,5 mm
  – the minimum admissible
about 1,5 mm

Back brakes

Back brakes drum-type also are equipped with the mechanism of automatic adjustment of a gap of blocks.

Brand:
  – berlin of 1,3 and 1,6 dm3
DBA
  – berlin of 2,0 dm3 and комби
Girling
Working diameter of a brake drum:
  – berlin of 1,3 and 1,6 dm3
203,2 mm
  – berlin of 2,0 dm3 and комби
228,6 mm
Width of blocks:
  – berlin of 1,3 and 1,6 dm3
38,1 mm
  – berlin of 2,0 dm3 and комби
57,1 mm
Diameter of working brake cylinders:
  – berlin of 1,3 and 1,6 dm3
19 mm
  – berlin of 2,0 dm3 and комби
20,64 mm
Thickness of slips:
  – the nominal:
     • block synchronous
4,75 mm
     • block asynchronous
3,25 mm
  – the minimum admissible:
1 mm
Type of blocks
N/F 360 IF.FF

DRIVING SYSTEM

Main brake cylinder

In a cavity of the main cylinder two pistons are located consistently, each of which operates the contour.

Vacuum amplifier of brakes

The vacuum amplifier of brakes influences the main brake cylinder and contains one diaphragm.

Pressure regulator

The regulator of pressure is established on the pipeline of back brakes and limit force of braking of back wheels.

Main brake cylinder
Brand
Bendix or Ate
Diameter of pistons
22,0-22,2 mm
Vacuum amplifier of brakes
The operating diameter
227 mm

Tightening moments

Support arm to a rotary fist of a wheel
5–75 Nanometers
Bearing disk to the lever
52-64 Nanometers
Connections of hydraulic pipelines
68-95 Nanometers
Deaerator
at most 10,5 Nanometers
Nut of fastening of a wheel
100 Nanometers