| 1. To remove a protective cap of a back wheel and to weaken nuts of fastening of a wheel. |
| 2. To weaken a nave nut on the semi-axis end. |
| 3. To lift and fix a back part of the car, to remove the corresponding wheel. |
| 4. To remove a brake drum (see subsection 10.3). |
| 5. To unscrew a nave nut on the semi-axis end. |
| 6. By means of a stripper with external captures to remove a wheel nave. |
| 7. To remove from within a bearing brake board a plastic casing of the external driving hinge of a semi-axis after a raising a screw-driver of tightening rings on heads of bolts and unscrewing of bolts of fastening of a casing. |
| 8. To unscrew and take four bolts of fastening of the case of bearings of a nave of a wheel to the lever of a suspension bracket and to take the case of bearings of a nave of a back wheel. |
| 9. To screw in freely two bolts of fastening (on a diagonal) cases of bearings of a nave after its extraction for deduction of a bearing brake board and preservation of a back brake hose. |
| 10. To take from the case of bearings of a nave of a wheel two sealing rings, and also conic bearings (external and internal). |
| 11. To beat out external rings of bearings a core from bronze. |
| 12. To clear an internal surface of the case of bearings of a nave of a wheel. |
| 13. To establish in the case by means of the adaptation 14.019 external rings of bearings. |
| 14. To grease with greasing space between bearings and to insert into the case conic bearings. |
| 15. To insert into the case sealing rings by means of the adaptation 14.019. |
| 16. To unscrew two bolts holding bearing board of the brake, and to insert the case of bearings of a nave of a wheel into bearing board of a brake. |
| 17. To screw up bolts of fastening of the case of bearings to the lever of a suspension bracket and to tighten them the corresponding moment. |
| 18. To establish a plastic casing of the external driving hinge of a semi-axis. |
| 19. To insert a nave flange on a semi-axis, to put on a semi-axis laying and to screw up a new nut without a final tightening. |
| 20. To establish a brake drum. |
| 21. To put on a wheel, to put the clamps fastenings of a wheel and to lower the car. |
| 22. To tighten the corresponding moment a nut of a nave of a wheel on the end of a semi-axis and to fix it stamping of a cylindrical part of a nut by a steel punch in a carving flute. |
| 23. To tighten the corresponding moment of a nut of fastening of a wheel. |