Ford Sierra

1982-1993 of release

Repair and car operation


Ford Siyerra
+ 1.2. Car identification
+ 2. Maintenance
+ 3. General data
+ 4. Engines
+ 5. Coupling
+ 6. Transmissions
- 7. Driveshaft and back bridge
   7.1. Technical characteristics
   7.2. Removal and driveshaft installation
   7.3. Repair of the intermediate bearing
   7.4. Removal and installation of the back bridge
   7.5. Dismantling and assembly of the back bridge
   7.6. Dismantling and differential assembly
   7.7. Adjustment of bearings of gear wheels of the main transfer
   7.8. Adjustment of gear wheels of the main transfer
   7.9. Assembly and adjustment of the main transfer
   7.10. Replacement of a sealing ring of a gear wheel of the main transfer
   - 7.11. Semi-axes
      7.11.1. Removal and installation
      7.11.2. Dismantling and assembly
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment






7.11.2. Dismantling and assembly
PERFORMANCE ORDER
1. To remove collars of fastening of protective casings of hinges of a semi-axis.
2. To cut a casing of hinges and to unbend them by means of the passatizhy.
3. By means of the adaptation for compression of springs to remove a semi-axis nave from the hinge.
4. To remove an external lock ring of the three-humeral hinge and to designate its situation concerning a semi-axis.
5. To move a protective casing along a semi-axis and by means of a stripper with three captures to remove the hinge.
6. To remove a lining from an artificial material, a casing and a rubber protective casing of the hinge.
7. To take a rubber ring of round section from a nave.
8. To clear and check all details, to replace worn out or damaged.
9. To establish on a semi-axis protective a casing, a casing and a lining from an artificial material (a convex surface directed from the hinge).
10. By means of the plug of the corresponding sizes to establish on a semi-axis the three-humeral hinge. Both hinges of a semi-axis should be displaced from each other on a corner 60 ° (using the designations made during dismantling).
11. To establish a lock ring.
12. By means of the adaptation for compression of springs to establish a semi-axis nave on the hinge. To fill the hinge in 15 grams of firm greasing.
13. To establish on a nave a rubber ring of round section.
14. By means of the corresponding stripper to establish a casing of the three-humeral hinge, having its edge in hinge flutes.
15. To clamp a casing on all perimeter.
16. To fill hinges in 65-85 grams of firm S-MIC 75 F or SQM-IC 9004 greasing.
17. To establish rubber protective a casing and to clamp new collars of fastening of casings.