Ford Sierra

1982-1993 of release

Repair and car operation



Ford Siyerra
+ 1.2. Car identification
+ 2. Maintenance
+ 3. General data
+ 4. Engines
+ 5. Coupling
- 6. Transmissions
   - 6.1. Mechanical four-speed transmission
      6.1.1. Technical characteristics
      6.1.2. Removal and transmission installation
      6.1.3. Dismantling and transmission assembly
      6.1.4. Dismantling and assembly of a transmission of type A and B
      6.1.5. Dismantling and assembly of a transmission of type C
   + 6.2. Mechanical five-speed transmission
   + 6.3. Automatic transmission of Ford C 3
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment






6.1.2. Removal and transmission installation

GENERAL INFORMATION

Prevention

This section concerns transmissions of all types.


Removal

PERFORMANCE ORDER
1. To establish the car over the viewing channel or to lift it on the lift.
2. To disconnect a weight wire from the accumulator.
3. To unscrew the handle of the lever of gear shifting.
4. To remove (depending on the equipment version) the average console or the shelf about the gear shifting lever.
5. To remove an external casing of the lever of gear shifting after a detachment it from the holder, and also an internal casing together with the holder after unscrewing of a frame of the holder from a floor tunnel.
6. To disconnect the gear shifting lever from a back part of a case of a transmission.
7. To lift the car.
8. To disconnect the stabilizer from a longeron.
9. To disconnect rubber elements of a suspension bracket from brackets of fastening of a back part of final system and to fix all system so that it did not load fastening of its forward part.
10. To unscrew fastening of the average bearing of the driveshaft, and also to unscrew driveshaft fastenings to a flange of a leading shaft of the main transfer, about the back bridge.
11. To take a forward part of the driveshaft from a back case of a transmission and to muffle the corresponding stopper an opening in a back part of a case for prevention of an effluence of oil from a transmission.
12. By means of a jack to prop up through wooden whetstones a transmission.
13. To unscrew a cross-piece of fastening of a transmission to a body.
14. To remove a spring hook of fastening of a cable of a drive of a speedometer and to disconnect a cable from a transmission.
15. To disconnect an electric wire from the switch of fires of a backing.
16. To remove a starter.
17. To disconnect a coupling cable from switching off forks.
18. To unscrew bolts of fastening of a transmission to a cross-piece.
19. To remove the jet lever of knot the engine – a transmission.
20. To disconnect a transmission from the engine and carefully to take a transmission from under the car.

Installation

PERFORMANCE ORDER
1. To cover shlitsa of primary shaft with a small amount of konsistentny greasing.
2. Installation of a transmission is carried out in sequence of return in relation to removal process.
3. After installation it is necessary to check oil level in a transmission.