Ford Sierra

1982-1993 of release

Repair and car operation


Ford Siyerra
+ 1.2. Car identification
+ 2. Maintenance
+ 3. General data
- 4. Engines
   + 4.1. Petrol engines
   - 4.2. Diesel engine
      + 4.2.1. Technical characteristics
      4.2.2. Check and adjustment of gaps of valves
      + 4.2.3. Fuel system
      + 4.2.4. Nozzles
      4.2.5. Glow plugs
      4.2.6. Compression check
      4.2.7. Air removal from fuel system
      4.2.8. Fuel filter
      4.2.9. Fuel pump, installation of the beginning of injection of fuel
      4.2.10. Adjustment of number of turns of idling
      - 4.2.11. The repair which is not demanding removal of the engine
         + 4.2.11.1. Head of the block of cylinders
         4.2.11.2. Removal and engine installation
         - 4.2.11.3. Dismantling, repair and engine assembly
            4.2.11.3.1. Installation of the back radical bearing
            4.2.11.3.2. Knot assembly piston rod
            4.2.11.3.3. Assembly of a drive of system of a gazoraspredeleniye
            4.2.11.3.4. Further assembly of the engine
         + 4.2.11.4. Greasing system
         + 4.2.11.5. Cooling system
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment






4.2.11.3.4. Further assembly of the engine
PERFORMANCE ORDER
1. To establish a pulley of a cranked shaft.
2. To eliminate oil or greasing traces on a bolt of fastening of a pulley of a cranked shaft, a washer and from a surface of connection of a pulley and a washer.
3. To put 3 drops of Frenetanch glue on a carving in an opening of a cranked shaft.
4. To tighten a bolt of fastening of a pulley of a cranked shaft the corresponding moment.
5. To establish a head of the block of cylinders of the engine (see subsection 4.2.11.1.1).
6. To establish coupling (see subsection 5.2).
7. To establish the fuel pump and to adjust the injection moment (see subsection 4.2.9).
8. To establish:
  – a cover of a head of the block of cylinders together with new laying (laying to paste to a cover to tighten nuts the moment of 3 Nanometers);
  – the thermostat of a regulator of the raised number of turns of the cold engine together with new copper laying and to tighten it the moment of 22,5 Nanometers;
  – glow plugs, their electric wire and that tire; candles to tighten the moment of 50 Nanometers;
  – pipelines of supply of fuel;
  – the generator together with the holder of the tension device;
  – the holder of the oil filter together with new laying;
  – the pipeline of supply of oil to an axis of levers of valves.
9. To attach a forward exhaust pipe to a final collector
10. To establish tension devices of maple belts, the auxiliary pump of system of a steering, the vacuum pump and the radiator fan.
11. To put on and pull maple belts.
12. To measure a gap of a drive of the oil pump.