Ford Sierra

1982-1993 of release

Repair and car operation

Ford Siyerra
+ 1.2. Car identification
+ 2. Maintenance
+ 3. General data
- 4. Engines
   - 4.1. Petrol engines
      + 4.1.1. Technical characteristics
      4.1.2. Adjustment of gaps of valves
      - 4.1.3. Ignition system
         4.1.3.1. The sensor of impulses with the Hall converter
         4.1.3.2. To distribute ignitions
         4.1.3.3. Switchboard
         4.1.3.4. Remarks on operation
         4.1.3.5. Installation of a corner of an advancing of ignition
         4.1.3.6. Determination of malfunctions
         4.1.3.7. Removal and installation of the distributor of ignition
      + 4.1.4. Fuel system
      + 4.1.5. The repair which is not demanding removal of the engine
      4.1.6. Removal and engine installation
      4.1.7. Engine dismantling
      4.1.8. Identification of cooperating parts
      4.1.9. Engine assembly
      4.1.10. Replacement of pistons
      4.1.11. Removal and installation of an intermediate shaft
      4.1.12. Gazoraspredeleniye system
      4.1.13. Greasing system
      + 4.1.14. Cooling system
      4.1.15. Suspension bracket of the power unit
      4.1.16. System of production of the fulfilled gases
   + 4.2. Diesel engine
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

4.1.3.5. Installation of a corner of an advancing of ignition

GENERAL INFORMATION

Control signs for installation of a corner of an advancing of ignition of ignition

1–constant sign,

2–a sign VMT of the piston of the 1st cylinder on a pulley

PERFORMANCE ORDER

1. To connect a stroboscopic lamp according to the instruction on its operation.

2. To disconnect the vacuum pipeline from the distributor ignitions (Bosch distributor).

3. To start the engine, to warm up it and to leave idling. To check value of number of turns of idling of the engine.

4. To check a corner of an advancing of ignition, directing a lamp on a pulley.

5. In case of determination of size of a corner of an advancing of ignition not corresponding to requirements to weaken fastening of the distributor of ignition and, turning it in the corresponding direction, to expose a sign of the correct size of a corner of an advancing of ignition with a constant sign 1. In ONS engines deeper notches on a flange of a pulley are located through 4 °, and small notches are in their axis of symmetry (allowing to establish a corner multiple 2 °).

6. To fix the distributor of ignition and to check installation of a corner of an advancing of ignition.